Laney NEXUS-SL Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Odbiorniki i wzmacniacze Laney NEXUS-SL. Laney NEXUS-SL User Manual Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj

Podsumowanie treści

Strona 2

HORNONOFFFULLHALFINPUTLINKPOWER RATING:600 WATTS RMS8 OHMSN410www.laney.co.ukSERIAL NUMBER DESIGNED AND ENGINEERED IN THE UK BY LANEYMODELN410MADE IN

Strona 3

10Front Panel ControlsPower Switch: This fully disconnects the mains power to the amplifier. On switching on, the standby light will flash until the s

Strona 4 - Important Safety Instructions

11RETURNMONO/RIGHTRETURN/LEFTShape Switch: This is a four position rotary switch; position one is a bypass or off condition, position two, three and f

Strona 5

12present on the amplifier signal sent to the USB right channel record, the headphones and the connected speakers).Touch: This control has a centre ne

Strona 6 - Introduction

Rear Panel Controls10Universal Power Inlet: This socket accepts a standard IEC grounded connector supplied with the product.The unit must be earthed u

Strona 7

Phones: Stereo jack is provided which can be used for headphones or a stereo feed to a PA system. There is a source switch which can be set to listen

Strona 8 - WITH TWO (8 Ohm)

15Mixer DeskorPowered CabSo what else can I connect?...DI: This connector is a balanced direct feed primarily go to a PA sound desk. It carries a g

Strona 9 - IN CHINA

16TunerFX UnitHeadphonesPhones: Stereo jack is provided which can be used for headphones or a stereo feed to a PA system. There is a source switch wh

Strona 10 - EXTENSION CABINETS

iPad, iPad mini®, Tablet or LaptopUSB: There is standard USB 2.0 audio I/O connector supporting the following:1. Ability to simultaneously rec

Strona 11 - Front Panel Controls

SPEAKON 1/4” JACK-COMBOSPEAKON 1/4” JACK-COMBOBlock Diagram18HI INPUTLOW INPUTMUTEGAIN SUBSONICFILTERSCOMP SHAPEEQDSPRAW / TUNERTUBE STAGEMAIN OUT

Strona 13

Tube Amp TipsTube amplifiers generally sound much warmer/sweeter than solid state transistor amplifiers but they also need a little more respect due t

Strona 14 - Rear Panel Controls

20Rack MountingVentilation: Ensure the amplifier is well ventilated and that the ventilation slots in the top, bottom & sides are not obstructed i

Strona 15

Operating Voltage Range: ~100V to ~240V 50-60Hz.Average power consumption: 200W(Measured at 1/8th continuous output power)Power Output: 2x500W

Strona 16

22FCC Compliancy StatementThis device complies with Part 15 of the FCC rules.Operation is subject to the following two conditions:1) This device may

Strona 18

WelcomeDear Player,Thank you very much for purchasing your new Laney product and becoming part of the worldwide Laney family. Each and every Laney uni

Strona 19 - Block Diagram

WARNING: When using electrical products, basic cautions should always be followed, including the following:1. Read these instructions. 2. Keep these i

Strona 21 - Rack Mounting

5Introduction+Design Features:+Hybrid Tube Bass Amplifier, "Loaded with a high voltage ECC83 tube for natural tube warmth and compression, along

Strona 22

6Professional Hybrid Tube Bass AmplificationSTUDIO LIVE

Strona 23

Up & running...HORNONOFFFULLHALFINPUTLINKPOWER RATING:400 WATTS RMS8 OHMSN115www.laney.co.ukSERIAL NUMBER DESIGNED AND ENGINEERED IN THE UK BY

Strona 24

HORNONOFFFULLHALFINPUTLINKPOWER RATING:400 WATTS RMS8 OHMSN115www.laney.co.ukSERIAL NUMBER DESIGNED AND ENGINEERED IN THE UK BY LANEYMODELN115MADE IN

Komentarze do niniejszej Instrukcji

Brak uwag